You are here: Wiki > start > simulations > southhumberside > shissue

Locked Page is locked

Table of Contents

SimSig South Humberside
Version Control
Wrong route messages
Other errors

SimSig South Humberside

Version Control

First Issue: Ver 2.218.76 issued 25 March 2011

=

Known Issues V2.218.76

Wrong route messages

  • Several locations, notably on both Scunthorpe East and Scunthorpe West panels, and also when routing into Immingham Reception Sidings (Immingham panel), may tell you that you have routed a train incorrectly even if you haven't. This is an error and in the interim may require some manual intervention to fix.

Other errors

1980s era only

  • Littlefield Level Crossing will not auto-raise for trains in the down direction.
  • Wellowgate Level Crossing will not auto-raise after the passage of down trains.
  • TD s in Signal P974's berth will not step to Signal P980's berth at Grimsby Town.

  • Signal P980 at Grimsby Town will clear even if the barriers at Garden Street LC are still raised.
  • TDs in Signal M13's (Grimsby Marsh Junction) TD berth will step to Signal P976's TD berth (at Grimsby Town).

Both eras

  • Several locations may not report trains as entering in Multiplay.
  • Track circuits between Marsh Jn. and Marsh Jn. sidings don't occupy correctly.
  • Trains booked to wait at Wrawby Junction arriving from Holton-Le-Moor will stop beyond Signal WJ17.
  • There are errors with Oxmarsh reversing locations; as such not all possible reversing moves are possible.
  • Even if the 'auto-lower' option is selected on start-up, some crossings lower too late for a driver to receive green signals.
  • When trains are sent into Cleethorpes CS, you will always get a message telling you that you didn't receive permission, even if you did.
  • Trains running round at Barnetby Reception Sidings that head towards Scunthorpe will need the next location manually stepping to 'Elsham'.
  • Barton Lane LC barriers will not lower automatically when a train approaches, even if the 'auto-lower' option is selected on start-up. However, they will lower when the train reaches either Oxmarsh or Ulceby (after passing over the LC).
  • When 'auto-lower' is enabled, some crossings may lower regardless of whether a train is approaching or a route has been set over them or not, even if it is impossible for the train to proceed over the crossing. This will cause a penalty for delays to road users, and, if the crossing is blocked, you will be unable to raise the barriers.

  • =

    S Humberside Contents

Last edited by GeoffM on 15/09/2016 at 03:00