Page 1 of 1
Track circuit failure in non-circuited track! 23/05/2020 at 19:31 #127051 | |
grahamj42
130 posts |
I had a clearing point violation at Auchterarder 5 with all points set normal and no track occupied as far as Perth. After some minutes of investigation, I found that a track circuit fault had been reported at Auchterarder, and in the Incident Control Panel, I found that AR3947 was occupied. AR3947 seems to be the berth track circuit for AR6, but it's drawn as non-circuited track. This is most unfair! Can we have a check in the code which prevents faults in invisible track circuits ? Log in to reply |
Track circuit failure in non-circuited track! 24/05/2020 at 10:01 #127062 | |
clive
2781 posts |
It's not that simple, I'm afraid. Something drawn as non-track-circuited is just a bit of decoration as far as the code is concerned, no different than platforms or station names. There are occasions where real TCs aren't drawn, so it's hard for code to distinguish the situation.
Log in to reply The following user said thank you: grahamj42 |
Track circuit failure in non-circuited track! 24/05/2020 at 10:36 #127063 | |
JamesN
1607 posts |
clive in post 127062 said:It's not that simple, I'm afraid. Something drawn as non-track-circuited is just a bit of decoration as far as the code is concerned, no different than platforms or station names. There are occasions where real TCs aren't drawn, so it's hard for code to distinguish the situation.It is possible for the developer to explicitly set those tracks as unable to fail though, which they have appeared to have done for almost every other bit of non-track-circuited track. I've raised a mantis ticket (30599) for the data issue that caused the original report. I do concur that the code wouldn't be able to tell the difference itself Log in to reply The following user said thank you: grahamj42 |
Track circuit failure in non-circuited track! 24/05/2020 at 21:27 #127090 | |
clive
2781 posts |
JamesN in post 127063 said:clive in post 127062 said:Other way round: you have to set the track as able to fail.It's not that simple, I'm afraid. Something drawn as non-track-circuited is just a bit of decoration as far as the code is concerned, no different than platforms or station names. There are occasions where real TCs aren't drawn, so it's hard for code to distinguish the situation.It is possible for the developer to explicitly set those tracks as unable to fail though, which they have appeared to have done for almost every other bit of non-track-circuited track. JamesN in post 127063 said: I do concur that the code wouldn't be able to tell the difference itselfThat was my point: there's no way to make a separate check (e.g. does the track circuit get drawn) that it should or shouldn't be able to fail. Log in to reply |
Track circuit failure in non-circuited track! 25/05/2020 at 18:25 #127116 | |
GeoffM
6370 posts |
clive in post 127090 said:That was my point: there's no way to make a separate check (e.g. does the track circuit get drawn) that it should or shouldn't be able to fail.To expand on that a bit: off-sim areas such as fringes are usually drawn to aid during development and testing, so "is it drawn" won't work. They're just not within the visible screen area in a release version. SimSig Boss Log in to reply The following user said thank you: grahamj42 |