Page 1 of 1
| west drayton 31/05/2022 at 14:20 #146686 | |
dizzydudes
11 posts |
Hi Are there any instructions for the west drayton to colnebrook branch, iv no idea on how to get trains down there what to do down there and get them back, thanks , Chris Log in to reply |
| west drayton 31/05/2022 at 14:45 #146687 | |
|
JamesN
1611 posts 
|
dizzydudes in post 146686 said:HiThere is a paragraph in the simulation manual that gives a basic outline; but it could possibly do with some fleshing out. Trains towards Thorney Mill / Colnbrook:- Set the route from 106 signal onto the branch, and operate the points and slot on the Ground Frame. The train will pull up to the start of section stop board and phone to request verbal permission to enter the section. Grant permission if able and train will proceed, the shunter will advise you when the train is clear of the section. Trains from Thorney Mill:- Shunter will call for permission for train to enter section. Grant permission if able and train will proceed to end of section board. Set route from 285 to 141 and operate points and slot on Ground Frame. Interpose TD at 141. Shunter will call to advise train is clear of section Trains from Colnbrook:- Shunter will request permission to dispatch train towards start of section board. Grant permission if able. Train will call in from start of section board, instructions then as per “from Thorney Mill” above. Last edited: 31/05/2022 at 14:47 by JamesN Reason: None given Log in to reply The following users said thank you: dizzydudes, alan_s, layth23 |