Page 1 of 1
Absolute Block section 22/09/2023 at 12:35 #153386 | |
Gnerandy
![]() 5 posts |
Can anyone please advise how to clear the signals protecting the ABS sections between Litchfield and Alrewas in both directions. I have followed the manual instructions as in requesting Line Clear and then showing train on line, but the protecting signals will not clear. Is there anything else I should be doing? Any help greatly appreciated. Log in to reply |
Absolute Block section 22/09/2023 at 13:11 #153388 | |
eps125
![]() 103 posts ![]() |
If for example, you had a train traveling on the down from Lichfield towards Alrewas you can do the following: Request line clear at the Lichfield end by left clicking the green "C" roundel, Grant the line clear at the Alrewas end by left-clicking the green "C" roundel, Then you can set the route from Lichfield TV6 signal to TV7 signal and then TV7 to the Grey "DM" arrow adjacent to the signal, Send train on the line at Lichfield by left clicking the red "O" roundel, Acknowledge train on the line at Alrewas by left-clicking the red "O" roundel. It is covered in more detail on the wiki. Log in to reply The following users said thank you: Hap, Gnerandy |
Absolute Block section 22/09/2023 at 15:18 #153389 | |
Steamer
![]() 3958 posts ![]() |
Gnerandy in post 153386 said:Can anyone please advise how to clear the signals protecting the ABS sections between Litchfield and Alrewas in both directions. I have followed the manual instructions as in requesting Line Clear and then showing train on line, but the protecting signals will not clear.Have you set it to Train On Line before clearing the signal? If so, that'll be the issue- the block needs to be at 'Line Clear' to set the route into the section, you then set it to TOL as the train enters the section. "Don't stress/ relax/ let life roll off your backs./ Except for death and paying taxes/ everything in life.../ is only for now." (Avenue Q) Last edited: 22/09/2023 at 15:19 by Steamer Reason: None given Log in to reply |