Page 1 of 1
| Clearing WP266 into Loco Siding 11/12/2011 at 04:27 #24846 | |
Kage
65 posts |
Is there some other condition, other than having the crossing lowered and cleared? I have 0R23 waiting to move, OD30 is already in the siding, but the TC length of the siding says 350m, so there should be more than enough room. (Looked on Google Earth, it was actually only about ~100m, sill more than enough room... Log in to reply |
| Re: Clearing WP266 into Loco Siding 11/12/2011 at 13:29 #24867 | |
jc92
3683 posts |
depends if the shunt route into the loco siding is permissive, and will therefore allow a call on, or not, in which case you will have to talk him past it at danger.
"We don't stop camborne wednesdays" Log in to reply |
| Re: Clearing WP266 into Loco Siding 12/12/2011 at 14:06 #24978 | |
|
Hpotter
205 posts |
Many thanks for finding this, can hold my hands up to an error... For the time being, you will need to talk the driver past the signal (WP266) at Danger. The next version of Worksop will have this problem rectified. Log in to reply |