Page 1 of 1
| [NotABug] eadcodes 06/11/2009 at 02:57 #198 | |
The Oracle
3 posts |
hi all recently been having a crack at sheffield (view version) and keep getting the recurring problem of headcodes blanking out on any train that goes into or through sheffield station i have had a look through the options but nothing seems to rectify it if its a part of the sim then i can live with it but if it isnt can anyone help? many thanks in advance Lee Log in to reply |
| [NotABug] eadcodes 06/11/2009 at 02:57 #3894 | |
|
The Oracle
3 posts |
hi all recently been having a crack at sheffield (view version) and keep getting the recurring problem of headcodes blanking out on any train that goes into or through sheffield station i have had a look through the options but nothing seems to rectify it if its a part of the sim then i can live with it but if it isnt can anyone help? many thanks in advance Lee Log in to reply |
| [NotABug] eadcodes 06/11/2009 at 06:54 #3895 | |
|
mfloyd
189 posts |
Lee, If you are using the shunt signals they have no berths assigned to them - only the main signals do. As long as the route goes from main signal to main signal the TD should interpose along. I don't think there are any exeptions on Sheff. Michael Ripley, Derbyshire Log in to reply |
| [NotABug] eadcodes 06/11/2009 at 18:30 #3905 | |
|
Lardybiker
771 posts |
To add to Micheals post, the locations with shunts don't have berths because those locations don't on the on the real panel. If a train is stopped for a period of time at one of these locations, a signaller would probably use a magnet on the panel with a note as a reminder of what train it is. On SimSig that isn't possible, obviously, so we have stick notes instead to do the same job (right click to access IIRC). You can use a sticky note to remind you what train it is and if you use what you called the headcode (the correct term is Train Description I believe), you can then click on it to get the TT up for that train. I also add time of departure too on a separate line so I know when to set the route for it. Log in to reply |
| [NotABug] eadcodes 06/11/2009 at 23:16 #3910 | |
|
The Oracle
3 posts |
cheers for the replies folks after reading through them it appears its my fault as i must admit i use the shunt signals when setting routes and thats whats causing my problems!!! thanks a lot for the help Lee Log in to reply |
| [NotABug] eadcodes 07/11/2009 at 10:45 #3915 | |
|
kbarber
1743 posts |
There's no need to use the shunt signals when setting routes from one main signal to the next Lee; the interlocking logic automatically clears any facing shunts within the main route (and clearly the train describer logic knows that & deals with descriptions accordingly).
Log in to reply |