Page 1 of 1
| Exeter St Davids to Central 31/10/2009 at 21:03 #180 | |
Simdmuk
155 posts |
Hi all Just out of interest I was looking at PC rails newly released "south Devon " sim for comparison. In the notes they described setting a route from St Davids to Central stating that you can only set the route between say E160 and E215 not E160-E213-E215 as E213/313 are only for shunt moves.In a book about the Exeter area resignalling I have, it states that a proceed aspect can only be given from St Davids if the route is clear to the end of Centrals platform(the same as gonig down the bank).I tried a move with "our" Exeter scrolly and found that you can set a route from E160 to E213 with a train occupying the platform at Central i.e bringing the train to a stand on the incline. I was wondering if this is correct? Log in to reply |
| Exeter St Davids to Central 31/10/2009 at 21:03 #3821 | |
|
Simdmuk
155 posts |
Hi all Just out of interest I was looking at PC rails newly released "south Devon " sim for comparison. In the notes they described setting a route from St Davids to Central stating that you can only set the route between say E160 and E215 not E160-E213-E215 as E213/313 are only for shunt moves.In a book about the Exeter area resignalling I have, it states that a proceed aspect can only be given from St Davids if the route is clear to the end of Centrals platform(the same as gonig down the bank).I tried a move with "our" Exeter scrolly and found that you can set a route from E160 to E213 with a train occupying the platform at Central i.e bringing the train to a stand on the incline. I was wondering if this is correct? Log in to reply |
| Exeter St Davids to Central 01/11/2009 at 05:22 #3824 | |
AndyG
1842 posts |
ESD to Central is uphill, the route downhill won't clear when set as described for Central to ESD ie 312-335, it has to be set onward into P3 or P1. {note the sand drag (SD) by 335, and the catch points after 213 to Exe Cen P3}. The gradient is about 1:37 IIRC, and about 80' height difference.
I can only help one person a day. Today's not your day. Tomorrow doesn't look too good either. Log in to reply |
| Exeter St Davids to Central 01/11/2009 at 08:58 #3825 | |
Peter Bennet
5402 posts |
I'm looking at Exeter at the moment, if anyone can confirm the reality I can fix that quite easily. Peter I identify as half man half biscuit - crumbs! Log in to reply |
| Exeter St Davids to Central 01/11/2009 at 09:16 #3826 | |
postal
5264 posts |
AndyG The safety precautions built into the route setting for trains coming down the hill from Central to St. Davids are obviously required for safety reasons. Going up the hill, I don't think there are the same safety issues, but there are operational issues. Given the steep upward incline from St Davids to Central, would you want to be able to set a route which could stop a train while on the incline? You can imagine all of the operational problems if you did that and a train stalled when trying to re-start. Fun for a SimSigger, but a bit of a pain in the rear in the real world. JG “In life, there is always someone out there, who won’t like you, for whatever reason, don’t let the insecurities in their lives affect yours.” – Rashida Rowe Log in to reply |
| Exeter St Davids to Central 01/11/2009 at 11:10 #3827 | |
|
Noisynoel
989 posts |
I'l check the box instructions when I'm back at work on Tuesday
Noisynoel Log in to reply |
| Exeter St Davids to Central 01/11/2009 at 11:20 #3828 | |
|
AndyG
1842 posts |
JG / PB Going uphill, the driver would only get a Y if route only half set, so could elect to wait at ESD until G shown. Similar situation as Dore Jn E/W Jns on Sheffield? I can only help one person a day. Today's not your day. Tomorrow doesn't look too good either. Log in to reply |
| Exeter St Davids to Central 01/11/2009 at 12:18 #3829 | |
|
Simdmuk
155 posts |
Many thanks for the replies guys. Thanks Noisynoel, your info will be greatly appreciated! I'm aware of the Down Waterloo technical restriction, but I was unaware that there may be similar for the Up Waterloo. I quite agree Andy, that from a procedural point of view it would be ludicious to send a train up the bank only to have it held on the incline(I've lived for nearly 20 years in that part of the world and I cannot recall ever seeing anything being held at E213/313). Its only when I read the blurb with the "other" sim that suggested there was a "technical" restriction on the Up Waterloo, that I played with "our" sim to see if this was so . As I said, in a book I've got,it mentions the Down bank bit but then goes on to say "similarly,the signal routing from St Davids to Central will not clear when the route is set unless the line is clear right through to the london end of the platform at Central.These conditions are designed to prevent a train being brought to a stand on the steep gradiant". This goes to suggest that there is a similar technical restriction on the Up as well as the Down. So It boils down too... Is there really a technical restriction or is it just a procedural one?. Log in to reply |
| Exeter St Davids to Central 03/11/2009 at 20:26 #3861 | |
GeoffM
6376 posts |
Looking at my photos, there is a pair of buttons at both 213 and 313, one for shunt routes from ExSD, and the other for main routes. So the first comment that setting from 160 to 215 would appear to be wrong. However, none of my photos show just the first route set - they all show either none at all, or all the way through to Exmouth Jn! I have a contact and will try to find out further. Steep as it is, today's units shouldn't have problems restarting on the hill. In the days of class 50s perhaps so. SimSig Boss Log in to reply |
| Exeter St Davids to Central 03/11/2009 at 23:03 #3869 | |
|
Simdmuk
155 posts |
Thanks Geoff I have to say that looking at the book there is a pic, which you can just make out the buttons by 213/313. And your quite right about todays units! Log in to reply |
| Exeter St Davids to Central 04/11/2009 at 18:50 #3873 | |
|
Quizman
276 posts |
AndyG said:Going uphill, the driver would only get a Y if route only half set, so could elect to wait at ESD until G shown.Andy - see this for two drivers who got greens all the way up the bank and ended up very pale. I was at ExSD when they left - they never got above 20mph. Oh dear wot a mistaka to maka. http://www.youtube.com/watch?v=pOqqf-cbqQk&feature=related Steve Log in to reply |
| Exeter St Davids to Central 04/11/2009 at 23:58 #3876 | |
|
Simdmuk
155 posts |
As yes, happy memories of the Exeter Railfair back in 94 when I was on the Exmouth trip with 80080+80079 stalling (with our coach getting stuck just over the catch points!).
Log in to reply |
| Exeter St Davids to Central 13/11/2009 at 19:31 #4053 | |
|
Peter Bennet
5402 posts |
We did not get to the bottom of this before the refresh so as it made sense I have made signal clearing conditional on a through route. It can be reversed at a later date if incorrect.
I identify as half man half biscuit - crumbs! Log in to reply |
| Exeter St Davids to Central 14/11/2009 at 14:01 #4078 | |
|
Simdmuk
155 posts |
Thanks Peter.As you said it, makes sense.
Log in to reply |