Page 1 of 1
| Signalling Irregularities At Springburn 28/11/2018 at 01:37 #113660 | |
Phil-jmw
675 posts |
Running the 1984 TT, I've just tried to signal 0T23 from Springburn Pfm.1 into St Rollox Works. I obtained permission then set a route from CC405 into the works. After being busy elsewhere on the sim for a couple of minutes, I noticed 0T23 was still at Pfm.1, CC405 had returned to danger and the route had dropped, but CC405 signal stem was still illuminated white. I cancelled the route and restroked it. The first crossover didn't move from the 'Normal' position, the first half of the route didn't illuminate but the second half did and the second crossover called 'Reverse', and CC405 position light cleared. After a few seconds however, the second crossover self-normalised, causing the route to cancel and CC405 Sig return to Danger. I keyed the second crossover 'Reverse' and called the route again. The first crossover failed to call 'Reverse' and no route is showing but CC405 has cleared. As if all of this wasn't enough, I then decided to play devil's advocate and set a route from CC323 for 2K40 to depart from Pfm.2 towards Stepps, this route called and the signal cleared across the bows of 0T23 with CC405 cleared in Pfm.1. I've attached saves taken in quick succession to capture each event as it occurred. Post has attachments. Log in to view them. Last edited: 28/11/2018 at 01:38 by Phil-jmw Reason: None given Log in to reply |
| Signalling Irregularities At Sprigburn 28/11/2018 at 01:40 #113661 | |
|
Phil-jmw
675 posts |
The title should read '...Springburn'. Editing the title doesn't correct it.
Log in to reply |
| Signalling Irregularities At Sprigburn 28/11/2018 at 02:28 #113662 | |
|
Phil-jmw
675 posts |
To get 0T23 into St Rollox I set him back behind CC403 Sig on the Up & Dn Springburn at Sighthill West Jn then ran him through Pfm 2 where the route from CC323 Sig worked fine.
Log in to reply |
| Signalling Irregularities At Springburn 28/11/2018 at 05:01 #113664 | |
GeoffM
6376 posts |
Phil-jmw in post 113661 said:The title should read '...Springburn'. Editing the title doesn't correct it.Fixed the thread title for you. Editing your post does indeed edit that post title, just not the thread as a whole (only mods can do that). I'll leave the rest for more knowledgeable people than I. SimSig Boss Log in to reply The following user said thank you: Phil-jmw |
| Signalling Irregularities At Springburn 28/11/2018 at 07:04 #113668 | |
Peter Bennet
5402 posts |
Am just working on an update for accumulated reports at the moment and this appears to have been resolved at some point. Peter I identify as half man half biscuit - crumbs! Log in to reply The following user said thank you: Phil-jmw |