Page 1 of 1
Failed shunt aspect displayed as off? 12/06/2019 at 22:09 #118945 | |
9pN1SEAp
![]() 1140 posts |
Hi, In the attached save... Train 2E68 came to a stand at E35 which wouldn't clear. Signaller cleared the route into P6 as shunt E35-E677 & E677-E137. E35 showed call-on and E677 went white. However, 2E68 then complaining because E677 unlit. After train was talked through the G/S it changed back to a red display as the route released. Is this a display/behaviour bug? Thanks Jamie Post has attachments. Log in to view them. Jamie S (JAMS) Log in to reply |
Failed shunt aspect displayed as off? 12/06/2019 at 22:28 #118946 | |
--miki--
![]() 68 posts |
From the wiki: Quote: Shunt signal aspects are not necessarily 'proved' lit, and so a failure will not necessarily be shown on the panel. Log in to reply |
Failed shunt aspect displayed as off? 13/06/2019 at 09:38 #118947 | |
kbarber
![]() 1723 posts |
9pN1SEAp in post 118945 said:Hi,Someone who knows the control tables would need to confirm, but I wonder if E677 unlit (it is a facing shunt in several routes from E35) would hold E35 at danger for one of those routes even though the fault wasn't indicated on the panel? Log in to reply |
Failed shunt aspect displayed as off? 13/06/2019 at 10:26 #118948 | |
DaveHarries
![]() 1280 posts |
I noticed the E677 bit myself when I took over Panel B and I did wonder if it was a bug. I expected that the signal would not go white if it was unlit. I wonder how it would show on a real ROC layout. Dave Log in to reply |
Failed shunt aspect displayed as off? 13/06/2019 at 10:30 #118949 | |
headshot119
![]() 4869 posts |
DaveHarries in post 118948 said:I noticed the E677 bit myself when I took over Panel B and I did wonder if it was a bug. I expected that the signal would not go white if it was unlit. I wonder how it would show on a real ROC layout.Well... It would depend if it was lamp proved or not. "Passengers for New Lane, should be seated in the rear coach of the train " - Opinions are my own and not those of my employer Log in to reply |
Failed shunt aspect displayed as off? 13/06/2019 at 14:26 #118951 | |
Stephen Fulcher
![]() 2055 posts |
In WR E10k interlocking, present shunts normally only require the shunt to be "Not On" in order for the main signal to clear. As long as the shunt is called to an off aspect, the main will clear, even if the shunt isn't lit. Log in to reply The following user said thank you: kbarber |