Page 1 of 1
Signal 238 reverting to red unexpectedly 19/07/2019 at 06:22 #119493 | |
Hawk777
![]() 386 posts |
Hi! I just discovered that, with an onward route from signal 238 and it showing green over yellow, if I then call a route from 244 to 240, then 238 reverts to red, despite not being involved in that route in any way. However it comes back to green over yellow if I also call a route from 242 to 238, and then goes back to red if I cancel the 242→238 route. I don’t see anything in the manual suggesting that this is normal.
Log in to reply |
Signal 238 reverting to red unexpectedly 20/07/2019 at 01:33 #119518 | |
flabberdacks
![]() 607 posts |
236/238/240 are located on a gantry right on the far side of the points, easily within view of 242/244. The track also curves slightly to the right in the up direction. When you set turnout routes in the area, signals which do not have a route set towards them may revert to stop. This is deliberate, to help prevent drivers 'reading-through' the signal they're meant to be obeying. This happens a few times in other areas of the sim as well. This photo shows the close signal spacing Log in to reply The following user said thank you: Hawk777 |