Page 1 of 1
| Gascoigne Wood Junction. 28/09/2023 at 16:57 #153441 | |
0D07
91 posts |
Afternoon, Whilst doing some testing on a York Winter 1999 Timetable that I have written. I have come across a strange issue when a train is brought to stand at GW 1831 Signal on the Sherburn Lines (Booked or just regulated to allow other trains to pass). The Driver comes on the telephone asking for "Permission to Proceed" once GW 1831 signal is cleared and the train begins to reverse. Only way to stop this is manually reverse the train. The same also occurs when running round trains in the down loop via GW 5919 signal the loco stops and then runs off towards M 702 or GW 1818 Signals again the only way to stop this is to manually reverse the loco back onto the train. Any help is appreciated Thanks, Zero Delta Zero Seven Log in to reply |
| Gascoigne Wood Junction. 28/09/2023 at 17:02 #153443 | |
|
JamesN
1607 posts |
There's a few potential causes - have you got a save we can examine to help narrow it down?
Log in to reply |
| Gascoigne Wood Junction. 28/09/2023 at 17:05 #153444 | |
|
0D07
91 posts |
Afternoon, Its on a TT that is under test at the moment and until its released (The Timetable that is) then no there is not a saved copy that I can distribute. Thanks, 0D07 Log in to reply |
| Gascoigne Wood Junction. 28/09/2023 at 17:31 #153446 | |
|
JamesN
1607 posts |
0D07 in post 153441 said:Afternoon,Mantis 39454 for the issue with GW Down Loop run rounds - in short, the sim wants junction then 5919 signal, but whilst looking for junction it goes beyond where it can see 5919 signal so drives off looking for the signal. I've proposed removing the requirement for GW Jn, but that may change timetabling requirements for those run rounds slightly. For your first paragraph – I've run single train test timetables through the area with no issue, whether holding them at 1831 or not. Without the replication of your exact circumstances provided by a save game, and the ability to apply diagnosis tools direct to that save game, there is nothing further I can offer in support. At my end everything is working as I'd expect and I cannot reproduce the issue you are experiencing unfortunately. Last edited: 28/09/2023 at 17:33 by JamesN Reason: None given Log in to reply |
| Gascoigne Wood Junction. 28/09/2023 at 20:42 #153449 | |
|
bill_gensheet
1413 posts |
0D07 in post 153444 said:Afternoon,If you copy out one of the trains that is giving you the problem into a new blank timetable and just run that it may give enough information. Take the save when you have a 'unpause and hands off it does it from here' situation. I guess when the train is approaching the red. Log in to reply |
| Gascoigne Wood Junction. 28/09/2023 at 21:03 #153451 | |
Steamer
3984 posts |
You could also get to the point just before the issue arises, then clear the timetable (Timetable-> Clear in the hamburger menu), then save the game and upload it. Anyone looking at the save will only be able to see the trains already in the sim and not the full timetable. Note that you will have to go back to a save made before the timetable was cleared if you wish to continue that particular run of the TT.
"Don't stress/ relax/ let life roll off your backs./ Except for death and paying taxes/ everything in life.../ is only for now." (Avenue Q) Log in to reply |