Page 1 of 1
The runaway train! 21/02/2010 at 18:45 #747 | |
goatnatter
![]() 22 posts |
When running the Bristol 1985 timetable by K Sickelmore, there is a freight train timetabled to Ashton Junction. By the time it gets to Malago Vale I always seem to have forgotten it's destination and I route it down the main line. Does anybody know why the driver doesn't get on the phone, but happily continues towards Taunton without a word of complaint. Obviously the solution is not top make a cock up in the first place, though as it isn't at very busy time, and it is good fun finding a suitable reversing point and sending it back. Thanks to K Sickelmore for a very enjoyable time-table. Blair Ramsay Log in to reply |
The runaway train! 21/02/2010 at 18:45 #6849 | |
goatnatter
![]() 22 posts |
When running the Bristol 1985 timetable by K Sickelmore, there is a freight train timetabled to Ashton Junction. By the time it gets to Malago Vale I always seem to have forgotten it's destination and I route it down the main line. Does anybody know why the driver doesn't get on the phone, but happily continues towards Taunton without a word of complaint. Obviously the solution is not top make a cock up in the first place, though as it isn't at very busy time, and it is good fun finding a suitable reversing point and sending it back. Thanks to K Sickelmore for a very enjoyable time-table. Blair Ramsay Log in to reply |
The runaway train! 21/02/2010 at 19:40 #6852 | |
UKTrainMan
![]() 1803 posts |
I can only presume that this is due to an error in the trains timetable itself. Looking at Bristol 1980s Based Era / Mode I cannot see a reason why it didn't question the route. That said, I've probably missed something somewhere and might be getting this wrong - not sure really. Any views and / or opinions expressed by myself are from me personally and do not represent those of any company I either work for or am a consultant for. Log in to reply |
The runaway train! 21/02/2010 at 20:36 #6857 | |
GeoffM
![]() 6344 posts |
An omission in the simulation data - it has to be told which routes are invalid for certain locations or situations (eg valid for non-stop trains at XYZ but not those stopping there).
SimSig Boss Log in to reply |
The runaway train! 22/02/2010 at 15:11 #6868 | |
goatnatter
![]() 22 posts |
Thanks for replies. I will have to place a suitable sticky note when the train first appears from Standish Jn (I think.) Blair Ramsay Log in to reply |