Upcoming Games

(UTC times)


Full list
Add a game

Upcoming Events

No events to display

Marylebome Problems

You are here: Home > Forum > General > General questions, comments, and issues > Marylebome Problems

Page 1 of 1

Marylebone Problems 21/12/2017 at 08:37 #104296
marquel41494
Avatar
7 posts
Me and a close friend were playing marylebone and iv'e found quite a few problems.

Sim-Marylebone
Era-New
Time Table--MYB Dec 13 SX from VPT v0.1

1--There are a lot of trains that are losing their ARS status even thou they are on the correct path. This problem is all over the sim.

2--Trains that are on ARS keep stopping at red signals despite the ARS being on in that area!. Found out that if the train is in ARS and its stopped at a signal, if you right click and tell it to run in ARS again, it continues on with its route thou it doesn't always work.

3--Trains that are running in the Down direction between Aylesbury and Marylebone via the LUL are getting stuck somewhere between Rickmansworth and Amersham. Trains going from Aylesbury to Marylebone on the same line were not effected at all. (THE LUL SECTION WAS NOT BEING USED DURING SIM OPS)

Thanks
Marq K

Marq K./ Tester I.T
Last edited: 21/12/2017 at 08:39 by marquel41494
Reason: None given

Log in to reply
Marylebome Problems 21/12/2017 at 09:12 #104297
tjfrancis
Avatar
359 posts
marquel41494 in post 104296 said:
Me and a close friend were playing marylebone and iv'e found quite a few problems.

Sim-Marylebone
Era-New
Time Table--MYB Dec 13 SX from VPT v0.1

1--There are a lot of trains that are losing their ARS status even thou they are on the correct path. This problem is all over the sim.

2--Trains that are on ARS keep stopping at red signals despite the ARS being on in that area!. Found out that if the train is in ARS and its stopped at a signal, if you right click and tell it to run in ARS again, it continues on with its route thou it doesn't always work.

3--Trains that are running in the Down direction between Aylesbury and Marylebone via the LUL are getting stuck somewhere between Rickmansworth and Amersham. Trains going from Aylesbury to Marylebone on the same line were not effected at all. (THE LUL SECTION WAS NOT BEING USED DURING SIM OPS)

Thanks
Marq K
Marq can you Provide with a save file and what era did you use as New is not a era on sim.

Thanks tony

I am dyslexic so please consider this when reading my posts
Log in to reply
Marylebome Problems 21/12/2017 at 09:14 #104298
MarkC
Avatar
1105 posts
Do you have a save that you can upload please, And what version of the loader and sim are you using?
Log in to reply
Marylebome Problems 22/12/2017 at 03:25 #104331
marquel41494
Avatar
7 posts
Loader Version-(4.6.6)
Sim version-(3.7)
Sim Era-(2016)

Post has attachments. Log in to view them.
Marq K./ Tester I.T
Log in to reply
Marylebome Problems 22/12/2017 at 04:05 #104332
GeoffM
Avatar
6376 posts
Online
marquel41494 in post 104296 said:
Me and a close friend were playing marylebone and iv'e found quite a few problems.

Sim-Marylebone
Era-New
Time Table--MYB Dec 13 SX from VPT v0.1

1--There are a lot of trains that are losing their ARS status even thou they are on the correct path. This problem is all over the sim.
I count two out of about 30, not including the one that's on its way to Bicester when it should be in Aylesbury.

The timetable description reads "MYB - Wembley Event Sun 020417" rather than Dec 13 SX - though you do appear to be running the correct era.

marquel41494 in post 104296 said:
2--Trains that are on ARS keep stopping at red signals despite the ARS being on in that area!. Found out that if the train is in ARS and its stopped at a signal, if you right click and tell it to run in ARS again, it continues on with its route thou it doesn't always work.
Part of that may be due to the ARS issue discussed elsewhere; another part may be the large number of subareas turned off; another part "it doesn't always work" may be due to misrouting and...

marquel41494 in post 104296 said:
3--Trains that are running in the Down direction between Aylesbury and Marylebone via the LUL are getting stuck somewhere between Rickmansworth and Amersham. Trains going from Aylesbury to Marylebone on the same line were not effected at all. (THE LUL SECTION WAS NOT BEING USED DURING SIM OPS)
...you're running a timetable that requires the full LUL section, not the simple version. The user that supplied that timetable ought to put that in the description really.

SimSig Boss
Last edited: 22/12/2017 at 04:11 by GeoffM
Reason: None given

Log in to reply