Page 1 of 1
| Anglesea Sidings 24/07/2021 at 00:32 #140712 | |
Controller Dan
4 posts |
In short, I'm creating a custom timetable and wan to know certain points. 1. When a train exits Anglesea siding, I get the message about the train departing the siding, yet when the train is due to depart, I never see the headcode popup nor does the train actually depart. 2. What's the timetable say about time it takes to get from Anglesea to Lichfield City because none of the official timetables cater to Anglesea. Thanks in Advance A tad dumb but still learning Last edited: 24/07/2021 at 01:59 by Controller Dan Reason: None given Log in to reply |
| Anglesea Sidings 24/07/2021 at 09:32 #140713 | |
Peter Bennet
5419 posts |
You have to manually interpose the TD at AN157 (Right click >i or select Interpose option) in reality that's what the signalman does. Developers can enable the auto interposing and some do, sometimes depending on the difficulty level. The line is some 4 miles long so at 20mph that's about 12 minutes before an entering train will arrive at the signal, you can check it's moving through the f2 table. Peter I identify as half man half biscuit - crumbs! Log in to reply |
| Anglesea Sidings 24/07/2021 at 09:39 #140714 | |
jc92
3701 posts |
Have you sent a train into Anglesea before one is due to come out? The branch is one train working so what goes up must come down so to speak. A train won't enter unless the branch is occupied
"We don't stop camborne wednesdays" Log in to reply |
| Anglesea Sidings 24/07/2021 at 10:13 #140715 | |
|
Peter Bennet
5419 posts |
jc92 in post 140714 said:Have you sent a train into Anglesea before one is due to come out? The branch is one train working so what goes up must come down so to speak. A train won't enter unless the branch is occupiedI don't have access to the data to check but I managed to run a train from the sidings to Lichfield without a previous train exiting. Peter I identify as half man half biscuit - crumbs! Log in to reply |
| Anglesea Sidings 24/07/2021 at 10:39 #140716 | |
JamesN
1613 posts |
The sectional running time in ITPS from Lichfield City to Brownhills is 15 minutes
Log in to reply |
| Anglesea Sidings 24/07/2021 at 15:24 #140722 | |
|
bill_gensheet
1432 posts 
|
Had you validated your timetable ? If a train's timetable is not valid, it will not enter. You need to answer the phone and give permission when the train is wanting to enter. As noted by Peter, you will need to interpose the TD yourself, one reason for the phone call. Attached a one train timetable that has been tested. Bill Post has attachments. Log in to view them. Log in to reply |