Page 1 of 1
| Diverting between Hanslope Junction and Hillmorton Junction question 11/04/2023 at 13:55 #151146 | |
ajax103
1120 posts |
I've been playing one of the Rugby Centre timetables and for some reason which I don't understand, a set of actions is occurring that according to the manual should not be happening. Basically in the early hours of the morning so about 98% of the traffic is freight, I thought I try out the diversion below so I set the route for a pair of Class 4 freights running non stop between the two junctions to run via Weedon vice Northampton in both the Up and Down directions however both times, I get the driver calling up saying wrong route set and asking if I wanted the train to not use the passing points on the via Northampton route. Now the manual says: Diversions Trains booked non-stop between Hanslope Junction and Hillmorton Junction may be routed via either Weedon or Northampton without a score penalty, and without drivers challenging the route. However, note that the Northampton route is much slower (and 2 miles longer) and will cause a time penalty to trains booked faster than 75mph (the Weedon line is signalled to 125mph (EPS) through much of its route). Sending a slow train via Weedon is likely to severely impact any expresses approaching from behind. So if the train isn't booked to stop anywhere on the Northampton route than why would a driver call up saying wrong route set and waste time calling up about it? Does the above only apply to passenger services? Log in to reply |
| Diverting between Hanslope Junction and Hillmorton Junction question 11/04/2023 at 14:25 #151147 | |
Hap
1038 posts |
Already reported: https://www.SimSig.co.uk/Forum/ThreadView/40322?postId=93460 Mantis 16915 applies. How to report an issue: www.SimSig.co.uk/Wiki/Show?page=usertrack:reportanissue Log in to reply The following user said thank you: ajax103 |