Doncaster Station SX 2019-01-09

You are here: Home > Forum > Simulations > Timetables > Doncaster (Station) > Doncaster Station SX 2019-01-09

Page 1 of 1

Doncaster Station SX 2019-01-09 20/11/2023 at 18:37 #154261
GeoffM
Avatar
6380 posts
Doncaster Station SX 2019-01-09

This thread is for discussion of the Doncaster North SX 2019-01-09 timetable.

SimSig Boss
Last edited: 20/11/2023 at 18:42 by GeoffM
Reason: Correction

Log in to reply
Doncaster Station SX 2019-01-09 20/11/2023 at 19:34 #154269
Alex_Idos
Avatar
8 posts
quick thing i noticed earlier. Trains booked for the WSL that are headed to the south (i.e. retford) will call a wrong route if you put them in 3A or 1 at Doncaster. Had a Grand Central call (1A70 i think it was) as i re-platformed. Not sure if this causes issues with other services that require similar (for example if you needed to put an ESL LNER on the WSL).

Not sure if it affects others but that's just one that caught my eye when running it

Complaining about the red you're sat at? Look for the freighter I just routed in front of you ^-^
Log in to reply
Doncaster Station SX 2019-01-09 20/11/2023 at 19:52 #154273
9pN1SEAp
Avatar
1189 posts
Online
One thing I noted from Saturday is that trains such as 0E16 if sent to reverse at D224, would traverse quite a way towards D219 before reversing and approaching close enough to get the call-on. Should the reverses be set with position near-end?

Thanks
Jamie

Jamie S (JAMS)
Log in to reply
Doncaster Station SX 2019-01-09 20/11/2023 at 20:07 #154280
GeoffM
Avatar
6380 posts
Alex_Idos in post 154269 said:
quick thing i noticed earlier. Trains booked for the WSL that are headed to the south (i.e. retford) will call a wrong route if you put them in 3A or 1 at Doncaster. Had a Grand Central call (1A70 i think it was) as i re-platformed. Not sure if this causes issues with other services that require similar (for example if you needed to put an ESL LNER on the WSL).

Not sure if it affects others but that's just one that caught my eye when running it :P
It's presumably booked that way for a reason - driver route knowledge retention perhaps. You could edit the timetable to remove Bridge and Decoy Junctions if you needed to re-route it.

SimSig Boss
Log in to reply
The following user said thank you: Meld
Doncaster Station SX 2019-01-09 20/11/2023 at 22:24 #154290
HST125Scorton
Avatar
1198 posts
2019 Midnight Start I have train 6B80 [H31734S] standing at Signal D218, he calls up asking to go, I checked the timetable it should held at St Catherines Jn for regulation but St Catherines Jn is behind the train, maybe the timetable should have St Catherines Jn Loop instead?
Aaron (AJRO) | Timetable Writer
Last edited: 20/11/2023 at 22:26 by HST125Scorton
Reason: None given

Log in to reply
Doncaster Station SX 2019-01-09 20/11/2023 at 23:33 #154293
Phil-jmw
Avatar
675 posts
If any of you have got up to around 0400 and noticed 3Q59 2340 Heaton - Derby RTC (enters 0343 Temple Hirst) losing time en route to Doncaster, this is because the Train Category 'CLS (3) 37+3 Test Train (30mph) 79m' is incorrect. It should be 'CLS (3) 37+3 Test Train 79m' as this train (a Network Rail Ultrasonic Test Unit) transited from York Holgate Jn (max speed 75mph) and then picked up recording from Doncaster to Grantham at 30mph ( the train category change at Doncaster is correctly shown in the TT).

As an aside, this UTU working normally gets driver relief at Doncaster Stn, so while 3Q59's TT does show a 3 minute through-line stop on the Up Fast, it is normally requested to be routed into Pfm.3 for relief as it's the safer option than relieving on the fast line, and whenever I've worked this train (testing crew) this is what has taken place.

Last edited: 20/11/2023 at 23:52 by Phil-jmw
Reason: None given

Log in to reply
Doncaster Station SX 2019-01-09 20/11/2023 at 23:49 #154294
Meld
Avatar
1111 posts
Phil-jmw in post 154293 said:
If any of you have got up to around 0400 and noticed 3Q59 2340 Heaton - Derby RTC (enters 0343 Temple Hirst) losing time en route to Doncaster, this is because the Train Category 'CLS (3) 37+3 Test Train (30mph) 79m' is incorrect. It should be 'CLS (3) 37+3 Test Train 79m' as this train (a Network Rail Ultrasonic Test Unit) transited from York Holgate Jn to Marshgate Jn (max speed 75mph) and then picks up recording from Doncaster to Grantham at 30mph ( the train category change at Doncaster is correctly shown in the TT).

As an aside, this UTU working normally gets driver relief at Doncaster Stn, so while 3Q59's TT does show a 3 minute through-line stop on the Up Fast, it is normally requested to be routed into Pfm.3 for relief as it's the safer option than relieving on the fast line, and whenever I've worked this train (testing crew) this is what has taken place.
Mantis 39771

Phil I've spent hours going through the CIF I may have missed a few in the process and the 3Qs only show OP stops so its harder to get the crew changes

H326121901081901080100000 is an overlay schedule

CRSKELTON DT3Q59 152495112 D 075Q
LISKELTON 0319H0320 00000000
LIYORK 0322 000000003 NNL
LICOLTONJ 0328 00000000
LIHAMBLNJ 0337 00000000
LITEMPLHJ 0343 00000000
LISHFTHLJ 0353 00000000
CRDONC DT3Q59 152495112 D 030Q
LIDONC 0358 0401 00000000UF OP

Passed the age to be doing 'Spoon Feeding' !!!
Log in to reply
Doncaster Station SX 2019-01-09 20/11/2023 at 23:59 #154296
Phil-jmw
Avatar
675 posts
Meld in post 154294 said:
Phil-jmw in post 154293 said:
If any of you have got up to around 0400 and noticed 3Q59 2340 Heaton - Derby RTC (enters 0343 Temple Hirst) losing time en route to Doncaster, this is because the Train Category 'CLS (3) 37+3 Test Train (30mph) 79m' is incorrect. It should be 'CLS (3) 37+3 Test Train 79m' as this train (a Network Rail Ultrasonic Test Unit) transited from York Holgate Jn to Marshgate Jn (max speed 75mph) and then picks up recording from Doncaster to Grantham at 30mph ( the train category change at Doncaster is correctly shown in the TT).

As an aside, this UTU working normally gets driver relief at Doncaster Stn, so while 3Q59's TT does show a 3 minute through-line stop on the Up Fast, it is normally requested to be routed into Pfm.3 for relief as it's the safer option than relieving on the fast line, and whenever I've worked this train (testing crew) this is what has taken place.
Mantis 39771

Phil I've spent hours going through the CIF I may have missed a few in the process and the 3Qs only show OP stops so its harder to get the crew changes

H326121901081901080100000 is an overlay schedule

CRSKELTON DT3Q59 152495112 D 075Q
LISKELTON 0319H0320 00000000
LIYORK 0322 000000003 NNL
LICOLTONJ 0328 00000000
LIHAMBLNJ 0337 00000000
LITEMPLHJ 0343 00000000
LISHFTHLJ 0353 00000000
CRDONC DT3Q59 152495112 D 030Q
LIDONC 0358 0401 00000000UF OP
You'll rarely, if ever, see crew change points for test trains as they present themselves depending on which drivers are rostered to work them, and will be geared to their individual route knowledge, amongst other things. As for the timings, only working out the speed from the timings (for UTU's) will give a clue as to whether they're recording or transiting.

Last edited: 21/11/2023 at 00:09 by Phil-jmw
Reason: None given

Log in to reply
Doncaster Station SX 2019-01-09 24/11/2023 at 11:58 #154422
andyallen4014
Avatar
373 posts
Online
I've ended up with two helpings of 6D95, missing rule? Save attached

Cheers,
Andy


Post has attachments. Log in to view them.
User | Multiplayer Host | Timetable Writer
Log in to reply
Doncaster Station SX 2019-01-09 24/11/2023 at 16:40 #154428
Meld
Avatar
1111 posts
andyallen4014 in post 154422 said:
I've ended up with two helpings of 6D95, missing rule? Save attached

Cheers,
Andy

Mantis 39815 for re-entry rule

Passed the age to be doing 'Spoon Feeding' !!!
Log in to reply
Doncaster Station SX 2019-01-09 24/11/2023 at 16:52 #154429
HST125Scorton
Avatar
1198 posts
HST125Scorton in post 154290 said:
2019 Midnight Start I have train 6B80 [H31734S] standing at Signal D218, he calls up asking to go, I checked the timetable it should held at St Catherines Jn for regulation but St Catherines Jn is behind the train, maybe the timetable should have St Catherines Jn Loop instead?
6B80 [H31734S]/6F80 [H31923S] under North Blyth GB 6B80 Decisions both trains as above seed in the wrong location and should be St Catherines Jn Loop?

Managed to get to 0500hrs with a couple of incorrect route errors by myself... I changed 3Q59 before it entered to save that having a slow slog into Donny.

Aaron (AJRO) | Timetable Writer
Log in to reply
Doncaster Station SX 2019-01-09 05/12/2023 at 21:53 #154610
bugsy
Avatar
1795 posts
Something I just noticed at 09:48 with the timetable of 4R79, which is in Down Decoy Siding No.4.
It's booked to Bridge Jn. and Doncaster DG, but at Decoy North Jn. it says "Line DFL" which I take to mean the Down Fast Line.
It should be DS1 (DS2 is occupied at signal D249) because neither Bridge Jn. nor the DG can be accessed from the DFL.

You can give me a ticking off if I'm wrong :)

Oddly enough, I reported a similar issue with this train on 28th November in post #154509 (put in the FAQ section), but the timetable was different then. It must have been altered in an update; can’t see how else.
.....


Post has attachments. Log in to view them.
Everything that you make will be useful - providing it's made of chocolate.
Log in to reply
Doncaster Station SX 2019-01-09 05/12/2023 at 21:58 #154611
bugsy
Avatar
1795 posts
Here is a saved game at 09:50 so that people can see what I mean.
Post has attachments. Log in to view them.
Everything that you make will be useful - providing it's made of chocolate.
Log in to reply
Doncaster Station SX 2019-01-09 05/04/2024 at 10:31 #155942
Javelin395
Avatar
274 posts
Currently playing the TT referred to in thread title and have noticed a little oddity at 23:00hrs.

4E50 was due into 2WG#1 but this loop is shown as being 420m in length whereas the train is 432m in length. I therefore held this train at D273 on the WS1 in order to allow a couple of other services to cross from Doncaster station to the Sheffield Main. When I finally allowed 4E50 to proceed it fitted into the 2WG#1 despite being longer than the loop !!

Post has attachments. Log in to view them.
Log in to reply
Doncaster Station SX 2019-01-09 04/07/2024 at 08:05 #157744
BenWright
Avatar
199 posts
I've noticed that the Class 90 sets are set to 125 mph but can only do 110 mph IRL


Post has attachments. Log in to view them.
Log in to reply
Doncaster Station SX 2019-01-09 05/07/2024 at 15:37 #157746
GeoffM
Avatar
6380 posts
BenWright in post 157744 said:
I've noticed that the Class 90 sets are set to 125 mph but can only do 110 mph IRL
We're not sure what happened as the master data set already has them at 110mph but we're investigating, with tea and no biscuits on standby for the errant drivers. Thanks.

SimSig Boss
Log in to reply
The following user said thank you: BenWright