Page 1 of 1
| run rounds 02/01/2012 at 11:16 #26631 | |
mask44
31 posts |
need a bit of help here , how can you do run rounds at washwood heath . Engine divides i set route up onto main line and then it just stands there and says READY TO DEPART BUT TRAIN IN FRONT , itried reverse direction and shunt forward but nothing seems to work .
Log in to reply |
| Re: run rounds 02/01/2012 at 11:22 #26633 | |
Steamer
3985 posts |
You might be doing it in the wrong place. These are the steps I use: 1. Signal the incoming freight train to Signal 212, which is on the Down Goods, to the left of the 'Washwood Heath No.1' label. 2. Set a route to signal 458 on the U&D Camp Hill Through Siding. 3. When the loco has detached and has moved to the Camp Hill siding, wait for a gap in main line traffic and set a route to signal 447 (on the Down Main, underneath the 'Washwood Heath No.1' label, then to signal 221 on the Down & Up Goods. 4. Wait for another gap in main line traffic and set a route back to 212. 5. Wait for the loco to join and the driver phoning up to say he's waiting at a red signal. "Don't stress/ relax/ let life roll off your backs./ Except for death and paying taxes/ everything in life.../ is only for now." (Avenue Q) Log in to reply The following user said thank you: mask44 |
| Re: run rounds 02/01/2012 at 11:32 #26638 | |
|
mask44
31 posts |
thanks will try that , i been putting on thr bi di track near powerbox
Log in to reply |
| Re: run rounds 02/01/2012 at 11:35 #26639 | |
|
AndyG
1842 posts |
See also simulation operation notes, under Centre panel.
I can only help one person a day. Today's not your day. Tomorrow doesn't look too good either. Log in to reply The following user said thank you: mask44 |