Page 1 of 1
Passing signals at danger through reversed points 23/05/2014 at 02:06 #60836 | |
eeldump
![]() 19 posts |
Apparently, in Westbury SimSig, sending a train through a danger signal (R500 in my case, as the Woodborough GF was throwing a fit) followed by reversed points (i.e. the crossover at Woodborough) sends the train merrily on its way, wrong-railing down the up line as if the points had been left normal. That can't be right! (It passed through the crossover at Heywood Road Jn in the same fashion, too!)
Log in to reply |
Passing signals at danger through reversed points 23/05/2014 at 05:18 #60837 | |
Stephen Fulcher
![]() 2055 posts |
I don't think there is anything wrong here. I am assuming you told a train to pass R500 at danger having operated Woodborough GF and the signal not having cleared when you gave the slot off the GF lever? If this is the case then the sim is working correctly, albeit confusingly. The GF points are only the set going between the Up Goods Loop and the Siding, the set between the Up Main and Up Goods Loop are powered off the panel. To get R500 to clear to the siding, you need the slot from the Ground Frame, AND set a route from R500 to the exit arrow in the siding. If you authorised R500 to be passed at danger with just the ground frame reversed and not the crossover itself, there is nothing to stop the train until it either gets into a Mexican Standoff with a train proceeding normally on the Up Main, or it arrives at W732 ground signal at Heywood Road. The way the ground frames in Westbury sim work is not completely prototypical, but the one at Woodborough is not far from accurate. Peter Bennet is aware of this and has made some modifications to remove the worst of the bugs that were present with them when the sim was converted to loader format. I personally do not like the idea of the points not being seen to move on the panel when the frames are operated, as it induces confusion into situations like the one you described here. On a Western Region panel, the signalman will be able to see that the points are detected in the correct position for any route he has to clear a signal for. Log in to reply |
Passing signals at danger through reversed points 24/05/2014 at 01:22 #60881 | |
eeldump
![]() 19 posts |
The problem with your analysis is that the *ground frame* points were normal (in fact, the train was on the main at that point!), but the *crossover* points where reversed, or showing as such at least! Could it be that I would have had to lock the crossover's points reverse to make the move I wanted?
Log in to reply |
Passing signals at danger through reversed points 24/05/2014 at 01:51 #60883 | |
BarryM
![]() 2158 posts |
Yes. When requesting a driver to pass a signal at danger, all facing points must be locked in the direction of travel to the next signal or siding. Barry Barry, Sydney, New South Wales, Australia Last edited: 24/05/2014 at 01:52 by BarryM Log in to reply The following users said thank you: ozrail, eeldump |
Passing signals at danger through reversed points 24/05/2014 at 20:31 #60911 | |
clive
![]() 2766 posts |
" said:Yes. When requesting a driver to pass a signal at danger, all facing points must be locked in the direction of travel to the next signal or siding.Note that this is a real railway requirement; SimSig doesn't enforce it in any way. Log in to reply The following user said thank you: BarryM |
Passing signals at danger through reversed points 24/05/2014 at 22:16 #60916 | |
ozrail
![]() 197 posts |
Another way is to "back Set" the route by setting a signal in the opposite direction to lock the points.
Log in to reply |