Page 1 of 1
| LTS 20/09/2015 at 18:11 #76080 | |
toneleary
5 posts |
Just a quick question. Just purchased the LTS sim. With regards to the R and F at East Ham depot. The wiki says that - The signaller should restore these points to the normal position as soon as possible after use to protect against runaways from the sidings. I cant seem to reset. Am I just being a bit dense here? What should I do?
Log in to reply |
| LTS 20/09/2015 at 19:06 #76081 | |
|
sloppyjag
480 posts 
|
Left click on each set of points to set them to the normal position.
Planotransitophobic! Log in to reply The following user said thank you: toneleary |
| LTS 20/09/2015 at 23:58 #76088 | |
flabberdacks
636 posts |
Even though the R&F indicator is flashing, you can't click on it directly. Just put the siding entry/exit points back into the Normal position by swinging them like you would any other set of points. That might be: left-clicking directly on the points until they are set for main-line moves (need to do this for both ends), or, set a main line route past the siding. Either way, the R&F indicator will no longer flash once the points are back in the Normal position. Note: if you use the left-click method to move a set of points, ensure you left click them a second time to ensure they are not locked by you (blue indication), and will release the next time a train approaches. Log in to reply The following user said thank you: toneleary |