Page 1 of 1
Reversing from Hunslet Down 26/12/2015 at 21:53 #79243 | |
AlexH
![]() 159 posts |
Various trains 4N13/4 for example are probably supposed to reverse coming out of the yard to get to Metherley Junction. They do not do this. They stop half out of the yards and never reverse.
Log in to reply |
Reversing from Hunslet Down 27/12/2015 at 12:56 #79251 | |
Mattyq
![]() 259 posts |
... or reverse then disappear.
Not fat ..... fluffy!! (G Iglesias) Log in to reply |
Reversing from Hunslet Down 27/12/2015 at 16:06 #79256 | |
grahamj42
![]() 130 posts |
If you let them out onto the Down Main they reverse correctly from 908 even if ARS says they are off their booked route.
Log in to reply |
Reversing from Hunslet Down 28/12/2015 at 14:38 #79284 | |
AlexH
![]() 159 posts |
I don't have ARS enabled, and I let them run onto the mainline and they did not reverse. They remained hanging half out of the sidings and thence refused to move anywhere, even after abandoning timetable.
Log in to reply |
Reversing from Hunslet Down 30/06/2016 at 03:29 #83303 | |
BarryM
![]() 2158 posts |
" said:I don't have ARS enabled, and I let them run onto the mainline and they did not reverse. They remained hanging half out of the sidings and thence refused to move anywhere, even after abandoning timetable.You need to signal S3855 for the train to clears the sidings and it will then reverse at S908 to run on the ARR/DEP road. Barry, Sydney, New South Wales, Australia Log in to reply |
Reversing from Hunslet Down 30/06/2016 at 18:41 #83312 | |
Lardybiker
![]() 771 posts |
Agree with BarryM. The train length are likely such that they don't fit between S908 and S3855 signals. You should be able to tell if this is what is happening be paying attention to what the train is doing and the phone calls you get. If this is the case I would expect the train in the "F2" list should show as stopped at S3855 and still facing the forward direction. If S3855 remains at red, the driver should also call in and ask what to do. Simply set an onward route from S3855 so the train can pull forward enough that the back of the train can get beyond S908. They then should reverse as expected. Such a situation isn't common but there are several places where this happens on other sims and you have to signal beyond the first signal the train encounters in order to give enough space for the train to correctly reverse. Last edited: 30/06/2016 at 18:44 by Lardybiker Log in to reply |