Page 1 of 1
| Signal 244 clearing before route set 02/08/2018 at 20:45 #110694 | |
Forest Pines
525 posts |
I have noticed when setting a route from 244 to 240, that 244 appears to change to a proceed aspect a little bit before the points are fully over - the points keep flashing for a second or two after the signal clears (to YY, naturally).
Log in to reply |
| Signal 244 clearing before route set 03/08/2018 at 01:18 #110700 | |
flabberdacks
649 posts |
Thanks for noting this. It's a known issue relating to the way points operate in sequence for route 244 to 240. A ticket is already open for its fixing.
Log in to reply The following user said thank you: Forest Pines |
| Signal 244 clearing before route set 02/04/2019 at 09:27 #117141 | |
|
Hawk777
386 posts |
Not sure if the ticket covers this, but it’s not just a matter of the order in which things appear to happen, it’s actually a wrong-side failure. If you fail reverse detection on points 602 and call route 244 to 240, 244 will clear, and remain clear, despite the points never proving at all. A train can then be brought up to 244, in which case it will pass it without complaint and proceed to 238 (assuming points are stuck normal, e.g. hand cranked), despite the route appearing to be set to 240.
Log in to reply |
| Signal 244 clearing before route set 20/07/2019 at 01:35 #119519 | |
|
flabberdacks
649 posts |
Yep, we know about it. Will be patched in the next update. Thanks!
Log in to reply |