Carlisle Shunt Moves

this was logged by me on Mantis as I had issues with 291 and 294 repeatedly while testing V5 loader. ticket is 30771. marked resolved - no change required. It might be best for Karl to comment further as and when he can as he is the current manager for that sim.

Can you confirm if you've had the same issue with 294 (you've confirmed 291) as that was a frequent offender, as was 6L81 at Tebay. also was this a pre V5 save or a fresh session?

Ps: only present workaround is to abandon TT as a train using the signal approaches it, manually reverse it and then reinstate tt.

jc92 in post 129743 said:

this was logged by me on Mantis as I had issues with 291 and 294 repeatedly while testing V5 loader. ticket is 30771. marked resolved - no change required. It might be best for Karl to comment further as and when he can as he is the current manager for that sim.

Can you confirm if you've had the same issue with 294 (you've confirmed 291) as that was a frequent offender, as was 6L81 at Tebay. also was this a pre V5 save or a fresh session?

Ps: only present workaround is to abandon TT as a train using the signal approaches it, manually reverse it and then reinstate tt.

30771 was marked No Change Required as there are two related tickets noted in the resolution notice where the actual fix was applied.

I would need a save game, and confirmation this was freshly started on simulation version 4.3 / Loader 5.0 or higher to investigate further.

EDIT

I've run a fresh game from midnight, and had no issues with the loco from 1M10.

headshot119 in post 129744 said:

jc92 in post 129743 said:

this was logged by me on Mantis as I had issues with 291 and 294 repeatedly while testing V5 loader. ticket is 30771. marked resolved - no change required. It might be best for Karl to comment further as and when he can as he is the current manager for that sim.

Can you confirm if you've had the same issue with 294 (you've confirmed 291) as that was a frequent offender, as was 6L81 at Tebay. also was this a pre V5 save or a fresh session?

Ps: only present workaround is to abandon TT as a train using the signal approaches it, manually reverse it and then reinstate tt.

30771 was marked No Change Required as there are two related tickets noted in the resolution notice where the actual fix was applied.

I would need a save game, and confirmation this was freshly started on simulation version 4.3 / Loader 5.0 or higher to investigate further.

EDIT

I've run a fresh game from midnight, and had no issues with the loco from 1M10.

Hi - Thanks for the responses. The signals I have had trouble with are reverses at 291 and 301. Not had a train reverse at 294 yet, but not sure one would reverse there as 301 is the logical place here to reverse trains to send trains into Wapping Sidings.

Saved game for 01:10 attached which shows 0M10 stopped the wrong side of sig 296 - I subsequently abandoned the tt when this occurred, and the re-instated it after I had manually reversed and set it on it's way again to Platform 1 only for it to occur again at sig 301 a few minutes later at approx 01:14, at which time I closed the SIM without saving the game. It would be good to see if you can find any issues.

The same thing happened earlier in the SIM for another train (0M49) that was sent to Wapping Sinding when it reversed at Platform 1. I again had to abandon the tt and manually reverse it to get it to enter Platform 1 so it could then reverse into Wapping.

Thanks for the help guys.