Page 1 of 1
| 7C23 and the lever frame at woodborough sidings 24/04/2021 at 15:49 #139011 | |
A350100BA
42 posts |
Can someone explain how to work the lever frame at wood borough sidings for 7C231?
Bon Log in to reply |
| 7C23 and the lever frame at woodborough sidings 24/04/2021 at 16:02 #139012 | |
Peter Bennet
5402 posts |
To get a train in you stop it behind R500, set the route into the sidings. Frame, tick the Annetts key, switch the point (black) and then the signal control (red). To get a train out open the frame, click the Annetts key, switch the point and then click the handsignal. Peter I've tweaked the manual to make the instructions clearer. I identify as half man half biscuit - crumbs! Last edited: 24/04/2021 at 16:10 by Peter Bennet Reason: Update about the manual Log in to reply |
| 7C23 and the lever frame at woodborough sidings 24/04/2021 at 16:37 #139014 | |
|
A350100BA
42 posts |
ahhh ok thank you
Bon Log in to reply |
| 7C23 and the lever frame at woodborough sidings 21/05/2021 at 06:57 #139644 | |
Orffen
9 posts |
I get a continual adverse change of signal aspect when trying to get a train out of the siding. This sends it into a telephone loop where it calls me up, I tell it to continue, it waits at the board, then I give it a hand signal and it gets the ACOA again. Quote:
Post has attachments. Log in to view them. Last edited: 21/05/2021 at 06:58 by Orffen Reason: None given Log in to reply |
| 7C23 and the lever frame at woodborough sidings 21/05/2021 at 11:55 #139648 | |
|
bill_gensheet
1413 posts |
Has worked OK for me. Maybe the 'handsignal' just times out while the train is approaching the stop board ? As for the timetable, this looks like the 'old' way to seed. Now it can be seeded at start. I do not see a conflicting train so could seed where it is at midnight (maybe DW59) 7C32 (at RC102) and 2C90 (at Westbury 102) could do with the same update if doing a revision. Bill Log in to reply |
| 7C23 and the lever frame at woodborough sidings 21/05/2021 at 21:54 #139655 | |
|
Peter Bennet
5402 posts |
Orffen in post 139644 said:I get a continual adverse change of signal aspect when trying to get a train out of the siding. This sends it into a telephone loop where it calls me up, I tell it to continue, it waits at the board, then I give it a hand signal and it gets the ACOA again.Hand is waved for 30 seconds but don't wave too early or you might get that report (under the bonnet it's just a signal that's made off). I did some mitigation in v4.5 - has that version been made available yet? Peter I identify as half man half biscuit - crumbs! Log in to reply The following user said thank you: Orffen |
| 7C23 and the lever frame at woodborough sidings 21/05/2021 at 22:20 #139657 | |
|
Albert
1315 posts |
Not yet, the Loader (freshly installed last weekend after upgrading the OS on my computer) is giving me 4.4.
AJP in games Log in to reply |