Upcoming Games

(UTC times)


Full list
Add a game

Upcoming Events

No events to display

Routing Question on Derby

You are here: Home > Forum > General > General questions, comments, and issues > Routing Question on Derby

Page 2 of 2

Routing Question on Derby 20/01/2019 at 14:11 #114931
kbarber
Avatar
1742 posts
Edgemaster in post 114881 said:
Tempest Malice in post 114878 said:

to avoid an RBC data change, it was requested that the new westlock covering the belle isle to canal tunnels junction should not TORR for routes used by trains under ETCS, as otherwise the RBC would see the route canceled under the train and give it an emergency stop when the route TORRed as currently to save data I believe the sub route relays aren't repeated to the RBC only the route relays so it would falsely see the route locking lost under the train if TORR were put in. Though I hopefully assume now that it has been agreed to change the interface and the RBC to take the subroute latches and allow TORR, but if when Kings cross is finally remodeled those particular routes don't TORR, that would be why.)
What is the standard operating procedure for cancelling routes behind trains? Does the signaller have to wait for the train to clear the route fully before cancelling behind? Will the potential limitations of subroute relays not being repeated to the RBC impose additional restrictions on manual cancellation of these routes?
It used to be, on a panel, that the entrance button could be pulled as soon as the train had completely passed the signal. (Somewhere in the Signalman's General Instructions? Or possibly Section C. But that was a long time ago and all sorts of things may have altered since then.) What TORR logic does, I really don't know.

Log in to reply
Routing Question on Derby 21/01/2019 at 21:25 #114963
Tempest Malice
Avatar
122 posts
kbarber in post 114825 said:
So the bobbies at the Cross are presumably used to having to pull up behind every train at one signal but letting TORR do it for them at the next.

Currently the situation for TORR in kingss coss is that: Hitchin has TORR on every signal except 226 & 227 (the two in the middle of Hitchin up yard, due to them being opposing locking omitted), Finsbury SSIs have TORR on 384 signal only (up slow 1 platform starter). I don't know since when or why for it being this way, just that that is the current SSI data.

kbarber in post 114931 said:
What TORR logic does, I really don't know.

Try pages 5 & 6 of the old railtrack standard for TORR for a slightly impenetrable description of the logic used to imlplement TORR.

And to drag the subject of the thread almost back to the derby sim; although the sim covers the PSB era, the new workstation covering the derby area has TORR throughout, with the TORR on the relay interlockings which weren't replaced (duffield and ambergate) being provided in the westronic tdm equipment (It check the outputs of the interlocking for the full sequence of TORR conditions, and when they occur sends a signal button pull into the interlocking which itself is unmodified). So the same interlocking that the SimSig sim is simulating, does now feature TORR in reality.

Last edited: 21/01/2019 at 21:26 by Tempest Malice
Reason: fix spelling

Log in to reply
The following user said thank you: BarryM
Routing Question on Derby 20/01/2022 at 16:54 #143692
postal
Avatar
5264 posts
Gents

Thank you all for taking the time to write up such in interesting and informative discussion.

“In life, there is always someone out there, who won’t like you, for whatever reason, don’t let the insecurities in their lives affect yours.” – Rashida Rowe
Log in to reply