Moses Gate ARS issue

Salford Crescent
Burnden Jn DPL
Bolton

should do it. Moses Gate Loop is not a key location and, as far as the sim is concerned, is the same place anyway. So you could insert Moses Gate Loops between Salford and Burnden if you wanted.

[NB not actually tested this, only looked at the data, because I'm in the middle of making changes on the Sale line and it won't currently compile).

GeoffM in post 131065 said:

Salford Crescent
Burnden Jn DPL
Bolton

should do it. Moses Gate Loop is not a key location and, as far as the sim is concerned, is the same place anyway. So you could insert Moses Gate Loops between Salford and Burnden if you wanted.

[NB not actually tested this, only looked at the data, because I'm in the middle of making changes on the Sale line and it won't currently compile).

Good call Geoff. Tested and working exactly as you suggested. Many thanks for that. Good luck with the MSJ&A branch!

What locations did you use?

I've just tested Salford Crescent-> Burnden Jn (Line DPL)-> Bolton (Plat 4)-> Lostock Jn. ARS routed fine into the DPL, but didn't set routes from 627 or 629. It did, however, set a route from 633 when the train was at Moses Gate. When manually routed, the train showed 'off planned path' once past 627 and ARS could only be re-enabled when approaching 633.

In the opposite direction, I've timetabled Bolton (P3)-> Burnden Jn (Line UPL)-> Salford Crescent. TT validates, however the train reports off planned path at all points on its journey.

Saves with example trains attached